Step 2
Home Page Wood Stripper

WOOD STRIPPER

Sherwood Wood Stripper removes all common types of wood coating, including alkyd enamels and varnishes, acrylic and nitrocellulose lacquers as well as acrylic wood coatings.

downloadDownload Technical Data Sheet

downloadDownload Material Safety Data Sheet

SHERWOOD WOOD STRIPPER is a step 1 PREPARE product and forms part of the SHERWOOD 3 STEP WOOD SOLUTION

Garage Door
PREPARE

Previously coated wood in poor condition:

  • Treat wood with SHERWOOD WOOD STRIPPER to remove old coatings, followed by SHERWOOD WOOD REVIVER to restore weather damage and to neutralise the wood surface.

Weathered wood:

  • Treat wood with SHERWOOD WOOD REVIVER to remove any weather damage on the wood surface.

New wood or previously coated in good condition:

  • No preparation products required.

APPLICATION
  • Apply product to the desired wood area with a brush or sponge.
  • Allow a minimum contact time of 10 minutes before washing off with a nylon scrubbing brush and running water.
  • Apply SHERWOOD WOOD REVIVER according to product specification on SHERWOOD WOOD REVIVER packaging to restore and neutralise the wood surface.
  • Leave to dry for 24 hours at 23°C before applying a STEP 2 PROTECT product.
  • Sand as per instruction of STEP 2 PROTECT product packaging.
  • All surfaces to be coated should be sound, clean, dry and free from sawdust and loose, flaking material after using the correct preparation products.
  • The coverage per litre will greatly depend on the type of coating and number of layers to be stripped off the wood.
  • Apply thick coats to small areas, approx. coverage 0.5 m2/litre.
CLEANING
  • Remove as much of the product as possible from the application equipment using cloth or paper towel before cleaning with water.
  • Always dispose of excess product or empty containers in a responsible manner without harming the environment by contacting a waste disposal organisation.
PROTECT

Choose your STEP 2 PROTECT product according to the desired finish and colour, examples included.

Interior products:

SHERWOOD INTERIOR VARNISH
SHERWOOD INTERIOR SEALER
SHERWOOD HARDWEARING VARNISH
SHERWOOD FLOOR VARNISH

Exterior products:

SHERWOOD EXTERIOR VARNISH
SHERWOOD EXTERIOR SEALER
SHERWOOD GARAGE DOOR SEALER
SHERWOOD DECK SEALER

For detailed application instructions for STEP 2 PROTECT products please refer to the packaging of the specific products.

MAINTAIN
  • As wood is a living material, regularly apply SHERWOOD INTERIOR or EXTERIOR WOOD PRESERVER to nourish the wood surface.
CAUTIONS
  • To ensure a consistent appearance, ensure that the batch numbers on all containers are the same.
  • Where batch numbers on containers differ, intermix before use.
SAFETY
  • Keep out of reach of children.
  • Wear a suitable dust mask when sanding.
  • Ensure adequate ventilation during application and drying.
  • Avoid contact with skin. If contact with skin should occur, wash immediately with warm water and soap or a recognised skin cleaner.
  • Avoid contact with eyes. In case of contact with eyes, rinse immediately with running water and seek medical advice.
  • If product is ingested, drink plenty of water or milk. Do not induce vomiting at any time. Seek medical advice.
STORAGE AND TRANSPORTATION
  • Store in a cool, dry place with adequate ventilation and away from open flames, direct heat or severe cold.
  • Keep container properly sealed.
  • To avoid any risk of spillage, always transport in a secure, upright position.